EasyManuals Logo

Cisco CRS-1 - Carrier Routing System Router Troubleshooting Guide

Cisco CRS-1 - Carrier Routing System Router
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
1-48
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
OL-21483-02
Chapter 1 General Troubleshooting
Validating and Troubleshooting Cisco IOS XR Software Configuration
router bgp 217
!!% Process did not respond to sysmgr !
RP/0/RP0/CPU0:router#
RP/0/RP0/CPU0:router# config
RP/0/RP0/CPU0:router(config)# load config failed startup noerror
Loading. 263 bytes parsed in 1 sec (259)bytes/sec
RP/0/RP0/CPU0:mike3(config-bgp)#show configuration
Building configuration...
telnet vrf default ipv4 server max-servers 5 router static
address-family ipv4 unicast
0.0.0.0/0 172.18.189.1
!
!
router bgp 217
!
end
The failed configuration is loaded into the target configuration, minus the errors that caused the startup
configuration to fail.
RP/0/RP0/CPU0:router(config-bgp)# commit
Use the show configuration failed command to display failed items in the last configuration commit,
including reasons for the error.
In any mode, the configuration failures from the most recent commit operation are displayed.
The show configuration failed command can be used in EXEC mode and configuration mode. The
command is used in EXEC mode when the configuration does not load during startup. The command is
used in configuration mode to display information when a commit fails.
The following example shows the show configuration failed command.
RP/0/RP0/CPU0:router(config)# interface pos 0/6/0/4
RP/0/RP0/CPU0:router(config-if)# no vrf
RP/0/RP0/CPU0:router(config-if)# commit
% Failed to commit one or more configuration items during an atomic operation, no changes
have been made. Please use 'show configuration failed' to view the errors
RP/0/RP0/CPU0:router(config-if)# exit
RP/0/RP0/CPU0:router(config)# show configuration failed
Wed May 2 13:14:08.426 EST EDT
!! CONFIGURATION FAILED DUE TO SEMANTIC ERRORS interface POS0/6/0/4 no vrf !!
% The interface's numbered and unnumbered IPv4/IPv6 addresses must be removed prior to
changing or deleting the VRF !
Note The show configuration failed command in configuration mode only exists as long as the configuration
session is active. Once you exit configuration mode, the command cannot be used to display the failed
configuration.
Commit Configuration Failed
The following example shows an invalid task ID configuration that fails to commit. The show
configuration failed command provides information on why the configuration failed.
RP/0/RP0/CPU0:router(config)# taskgroup isis

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS-1 - Carrier Routing System Router and is the answer not in the manual?

Cisco CRS-1 - Carrier Routing System Router Specifications

General IconGeneral
BrandCisco
ModelCRS-1 - Carrier Routing System Router
CategoryNetwork Router
LanguageEnglish

Related product manuals