3-100
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
OL-21483-02
Chapter 3 Troubleshooting Forwarding
Troubleshooting the Interface Manager
Third Party Registrations
Create/Delete State MTU Memory (bytes)
-----------------------------------------------------------------------
36 6 7 1072
-----------------------------------------------------------------------
IM->IMD communications information
Type Chunk Sz #Chunks Used Max Mem Max Mem
----------------------------------------------------------------------------
Big 1024 30 0 0 0 0
Small 512 300 44 1358 880 106800
No-chunk 0 0 0 0 0 0
Total 330 44 1358 880 106800
----------------------------------------------------------------------------
Pre-allocated memory for small chunks : 155057 bytes
Pre-allocated memory for big chunks : 31095 bytes
----------------------------------------------------------------------------
Transmit queue size: 142 elements
[range MIN:100 -> MAX:1000
based on nfn size: 108 bytes, optimal msg size: 15376 bytes]
----------------------------------------------------------------------------
Comms type Count #Elem Average Success #Retry Fail #Retry
Tx start 1875 945489 504 72 0 0 0
Tx done 73 4054 55
----------------------------------------------------------------------------
Total bytes sent: 186332
attempted: 186332
----------------------------------------------------------------------------
Checkpoint information
----------------------------------------------------------------------------
Timer Expiries : 234
Checkpoints : 19
----------------------------------------------------------------------------
Node status Chkptd Avg nodes/chkpt Bytes chkptd Avg bytes/chkpt
Clean 300 15 35360 1861
Dirty 2616 137 353984 18630
Total 2916 153 389344 20491
----------------------------------------------------------------------------
Memory summary
----------------------------------------------------------------------------
Total memory reserved : 1251438 bytes
Total memory used : 997670 bytes
----------------------------------------------------------------------------
Troubleshooting the Trace Logs for the Interface Manager
To debug the problem that occurred on the router and the IM, use the show im trace command with both
the location and internal keywords to trace logs that are recovered from the router for the applicable
location.
The debug im errors command enables the server for error debugging. When the problem is narrowed
down, debugging is enabled to provide more information.
The debug im callbacks command is used to display when notifications are arriving at the clients from
IM or Interface Manager Distributor (IMD). In addition, the command checks to see the number and
types of messages that are in the set of notifications.