EasyManuals Logo

Cisco CRS-1 - Carrier Routing System Router Troubleshooting Guide

Cisco CRS-1 - Carrier Routing System Router
264 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #258 background imageLoading...
Page #258 background image
13-248
Cisco IOS XR Troubleshooting Guide for the Cisco CRS-1 Router
OL-21483-02
Chapter 13 Troubleshooting Load Balancing
Configuration Examples for Troubleshooting Load Balancing
Enter L4 protocol (TCP,UDP,SCTP,L2TPV3,NONE): TCP
Enter src port: 5500
Enter destination port: 80
Compute destination address set for all members? [y/n]: y
Enter subnet prefix for destination address set: 10.0.0.0
Enter bundle IP V4 address [192.168.254.1]: 10.12.48.1
S/D pair 192.168.254.1:5500/10.1.2.1:80 -- Link hashed to is GigabitEthernet0/6/5/5
Destination address set for subnet 10.0.0.0:
S/D pair 192.168.254.1:5500/10.0.0.3:80 hashes to link GigabitEthernet0/6/5/5
S/D pair 192.168.254.1:5500/10.0.0.9:80 hashes to link GigabitEthernet0/6/5/6
S/D pair 192.168.254.1:5500/10.0.0.1:80 hashes to link GigabitEthernet0/6/5/7
This shows that an ingress flow from 192.168.254.2:5500 on interface GigabitEthernet0/6/5/4 to
destination 10.1.2.1:80 would use egress interface GigabitEthernet0/6/5/5. You can verify that this
occurs by viewing the traffic for each of the bundle links, as shown in the following excerpts from show
interfaces:
RP/0/RP0/CPU0:RouterB# show interface Gi0/6/5/6
Tue Oct 28 03:43:18.783 PST DSTGigabitEthernet0/6/5/5 is up, line protocol is up
...
16196 packets output, 875154 bytes, 0 total output drops
Output 0 broadcast packets, 12 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
RP/0/RP0/CPU0:RouterB# show interface Gi0/6/5/6
Tue Oct 28 03:43:18.783 PST DST
GigabitEthernet0/6/5/6 is up, line protocol is up
...
3 packets output, 372 bytes, 0 total output drops
Output 0 broadcast packets, 3 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
RP/0/RP0/CPU0:RouterB# show interface Gi0/6/5/7
Tue Oct 28 03:43:23.482 PST DST
GigabitEthernet0/6/5/7 is up, line protocol is up
...
3 packets output, 372 bytes, 0 total output drops
Output 0 broadcast packets, 3 multicast packets
0 output errors, 0 underruns, 0 applique, 0 resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
This verifies that the flow is using GigabitEthernet0/6/5/5, as expected. The other two links in the bundle
have incidental traffic.
Repeat this procedure for other flows. For example, for a flow exactly the same as the first except that
the destination port is 23, the bundle hash utility provides the following information:
RP/0/RP0/CPU0:RouterB# bundle-hash bundle-ether 12
Tue Oct 28 03:56:48.786 PST DST
Specify load-balance configuration (L3/3-tuple or L4/7-tuple) (L3,L4): L4
Single SA:SP/DA:SP pair (IPv4,IPv6) or range (IPv4 only): S/R [S]: S

Table of Contents

Other manuals for Cisco CRS-1 - Carrier Routing System Router

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco CRS-1 - Carrier Routing System Router and is the answer not in the manual?

Cisco CRS-1 - Carrier Routing System Router Specifications

General IconGeneral
BrandCisco
ModelCRS-1 - Carrier Routing System Router
CategoryNetwork Router
LanguageEnglish

Related product manuals