Lag During Boot up Due to Power Characterization Check
The power characterization test is run only once when you plug in and power up the CE1100. If the power
characterization test continues to run, causing a lag in the boot time, ensure that it is disabled in the CIMC. To do so:
1. Log in to the CIMC (see Connect Using the CIMC Port, page 12).
2. Go to Server > Power Policies > Power Cap Configurations.
3. Ensure that the Power Characterization at Boot check box is unchecked.
4. Click Save Changes.
18
Cisco Expressway CE1100 Appliance Installation Guide
Troubleshooting
To Next Page
Loading...
