Cisco expressway ce1100 User Manual

Introduction
About This Document
This document describes how to install a Cisco Expressway appliance into your video network. It contains information
on:
■ Preparing the installation.
■ Installing the hardware.
■ Performing the initial configuration.
■ Troubleshooting the installation.
About the Cisco Expressway Appliance
The Cisco Expressway appliance described in this document is a CE1100, which is based on a UCSC220 M4L. For
more detailed information on installing this appliance, see the Cisco UCS C220 Server Installation and Service Guide.
The appliance ships with the Cisco Expressway software pre-installed, and you can upgrade the software if
necessary.
The appliance supports Cisco Expressway version X8.6.1 or later.
Note: If you choose to use the copper SFPs, the unit cannot support more than 150 traversal calls. This is the case
even if the option key for extra traversal calls has been installed.
Item Part Quantity
Chassis UCS-C220-M4L 1
Processor UCS-CPU-E52637D (3.5 GHz/ 4 core - hyper threaded) 2
RAM UCS-MR-1X162RU-A (16GB) 2
Hard Disk
UCS-HD2T7KL12G 2
Onboard SAS Controller UCSC-MRAID12G (Cisco 12G SAS Modular Raid Controller, 1 GB
cache and SuperCap)
1
NIC N2XX-AIPCI01 (Intel X520 Dual Port 10Gb SFP+ Adapter) 1
EXP-10GSFP-SR (10Gb SR Fiber SFP) 2
EXP-1GSFP-T (1Gb Copper SFP) 2
PSU UCSC-PSU1-770W & power cable 2
TPM UCSX-TPM2-001 (Trusted Platform Module) 1
SDCard UCS-SD-32G-S (32GB SD Card for UCS servers) 1
Miscellaneous UCSC-RAILF-M4 (Rail kit) 1
UCSC-HS-C220M4 (Heat sink) 2
UCSC-MLOM-BLK (MLOM blank panel) 1
UCSC-BBLKD-L (3.5-inch HDD blank panel) 2
Table 2 Components for this Appliance
5
Cisco Expressway CE1100 Appliance Installation Guide
Introduction

Cisco expressway ce1100 Specifications

General

Brand	Cisco
Model	expressway ce1100
Category	Server
Language	English