Defaults or previously entered values appear in brackets. To accept previously entered values, press Enter.
See the following guidelines:
• Do you want to configure IPv4? and/or Do you want to configure IPv6?—Enter y for at least one of
these types of addresses. Although you do not plan to use the Management interface, you must set an IP
address, for example, a private address.
• Configure IPv4 via DHCP or manually? and/or Configure IPv6 via DHCP, router, or
manually?—Choose manual. You cannot configure a data interface for management if the management
interface is set to DHCP, because the default route, which must be data-interfaces (see the next bullet),
might be overwritten with one received from the DHCP server.
• Enter the IPv4 default gateway for the management interface and/or Enter the IPv6 gateway for
the management interface—Set the gateway to be data-interfaces. This setting forwards management
traffic over the backplane so it can be routed through the manager access data interface.
• Manage the device locally?—Enter no to use CDO. A yesanswer means you will use the device manager
instead.
• Configure firewall mode?—Enter routed. Outside manager access is only supported in routed firewall
mode.
Example:
You must accept the EULA to continue.
Press <ENTER> to display the EULA:
End User License Agreement
[...]
System initialization in progress. Please stand by.
You must configure the network to continue.
Configure at least one of IPv4 or IPv6 unless managing via data interfaces.
Do you want to configure IPv4? (y/n) [y]:
Do you want to configure IPv6? (y/n) [y]: n
Configure IPv4 via DHCP or manually? (dhcp/manual) [manual]:
Enter an IPv4 address for the management interface [192.168.45.61]: 10.89.5.17
Enter an IPv4 netmask for the management interface [255.255.255.0]: 255.255.255.192
Enter the IPv4 default gateway for the management interface [data-interfaces]:
Enter a fully qualified hostname for this system [firepower]: 1010-3
Enter a comma-separated list of DNS servers or 'none'
[208.67.222.222,208.67.220.220,2620:119:35::35]:
Enter a comma-separated list of search domains or 'none' []: cisco.com
If your networking information has changed, you will need to reconnect.
Disabling IPv6 configuration: management0
Setting DNS servers: 208.67.222.222,208.67.220.220,2620:119:35::35
Setting DNS domains:cisco.com
Setting hostname as 1010-3
Setting static IPv4: 10.89.5.17 netmask: 255.255.255.192 gateway: data on management0
Updating routing tables, please wait...
All configurations applied to the system. Took 3 Seconds.
Saving a copy of running network configuration to local disk.
For HTTP Proxy configuration, run 'configure network http-proxy'
Manage the device locally? (yes/no) [yes]: no
DHCP server is already disabled
DHCP Server Disabled
Configure firewall mode? (routed/transparent) [routed]:
Configuring firewall mode ...
Cisco Firepower 2100 Getting Started Guide
145
Threat Defense Deployment with CDO
Perform Initial Configuration Using the CLI
To Next Page
Loading...
Need help?
General