You connect to the FXOS CLI. Log in to the CLI using the admin username and the password you set at
initial setup (the default is Admin123).
Example:
firepower login: admin
Password:
Last login: Thu May 16 14:01:03 UTC 2019 on ttyS0
Successful login attempts for user 'admin' : 1
firepower#
Step 2 Access the threat defense CLI.
connect ftd
Example:
firepower# connect ftd
>
After logging in, for information on the commands available in the CLI, enter help or ?. For usage information,
see Cisco Secure Firewall Threat Defense Command Reference.
Step 3 To exit the threat defense CLI, enter the exit or logout command.
This command returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?.
Example:
> exit
firepower#
Troubleshoot Management Connectivity on a Data Interface
Model Support—Threat Defense
When you use a data interface for the management center instead of using the dedicated Management interface,
you must be careful about changing the interface and network settings for the threat defense in the management
center so you do not disrupt the connection. If you change the management interface type after you add the
threat defense to the management center (from data to Management, or from Management to data), if the
interfaces and network settings are not configured correctly, you can lose management connectivity.
This topic helps you troubleshoot the loss of management connectivity.
View management connection status
In the management center, check the management connection status on the Devices > Device
Management > Device > Management > FMC Access Details > Connection Status page.
At the threat defense CLI, enter the sftunnel-status-brief command to view the management connection
status. You can also use sftunnel-status to view more complete information.
Cisco Firepower 2100 Getting Started Guide
92
Threat Defense Deployment with a Remote Management Center
Troubleshoot Management Connectivity on a Data Interface
To Next Page
Loading...
Need help?
General