Ignore the Type drop-down list; the only available type is Data.
d) From the Admin Speed drop-down list, choose the speed for all member interfaces.
If you choose interfaces that are not capable of the speed (and other settings that you choose), the fastest
possible speed is automatically applied.
e) Click the Auto Negotiation Yes or No radio button for all member interfaces.
f) Admin Duplex drop-down list, choose the duplex for all member interfaces.
g) In the Available Interface list, select the interface you want to add, and click Add Interface.
You can add up to 16 interfaces of the same type and speed. The first interface added to the channel group
determines the correct type and speed.
You can add multiple interfaces at one time. To select multiple individual interfaces, click
on the desired interfaces while holding down the Ctrl key. To select a range of interfaces,
select the first interface in the range, and then, while holding down the Shift key, click to
select the last interface in the range.
Tip
h) Click OK.
Log Into ASDM
Launch ASDM so you can configure the ASA.
Strong Encryption (3DES/AES) is available for management connections before you connect to the License
Authority or Satellite server so you can launch ASDM. Note that ASDM access is only available on
management-only interfaces with the default encryption. Through the box traffic is not allowed until you
connect and obtain the Strong Encryption license.
Before you begin
See the ASDM release notes on Cisco.com for the requirements to run ASDM.
Procedure
Step 1 Using a supported browser, enter the following URL.
https://management_ip/admin
• management_ip—Identifies the IP address or host name of the ASA management interface (192.168.45.1).
The Cisco ASDM web page appears. You may see browser security warnings because the ASA does not have
a certificate installed; you can safely ignore these warnings and visit the web page.
Step 2 Click one of these available options: Install ASDM Launcher or Run ASDM.
Step 3 Follow the onscreen instructions to launch ASDM according to the option you chose.
The Cisco ASDM-IDM Launcher appears.
Cisco Firepower 2100 Getting Started Guide
216
ASA Deployment with ASDM
Log Into ASDM
To Next Page
Loading...
Need help?
General