Cisco Firepower 2100 User Manual

• The Firepower 2100 supports EtherChannels in Link Aggregation Control Protocol (LACP) Active or
On mode. By default, the LACP mode is set to Active; you can change the mode to On at the CLI. We
suggest setting the connecting switch ports to Active mode for the best compatibility.
• To change the management IP address from the default, see (Optional) Change the FXOS and ASA
Management IP Addresses or Gateway, on page 208.
Procedure
Step 1 In the chassis manager, click Interfaces.
The All Interfaces page shows a visual representation of the currently-installed interfaces at the top of the
page and provides a listing of the installed interfaces in the table below.
Step 2 To enable or disable an interface, click Enable slider ( ) or Disable slider ( ).
The Management 1/1 interface shows as MGMT in this table.
Note
Step 3 (Optional) Add an EtherChannel.
EtherChannel member ports are visible on the ASA, but you can only configure EtherChannels
and port membership in FXOS.
Note
a) Click Add Port Channel above the interfaces table.
b) In the Port Channel ID field, enter an ID for the port channel. Valid values are between 1 and 47.
c) Check the Enable check box to enable the port channel.
Cisco Firepower 2100 Getting Started Guide
215
ASA Deployment with ASDM
(Optional) Enable Additional Interfaces in the Chassis Manager

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English