[...]
firepower#
Step 2 At the FXOS CLI, show the running version.
scope ssa
show app-instance
Example:
Firepower# scope ssa
Firepower /ssa # show app-instance
Application Name Slot ID Admin State Operational State Running Version Startup
Version Cluster Oper State
-------------------- ---------- --------------- -------------------- ---------------
--------------- ------------------
ftd 1 Enabled Online 7.6.0.65 7.6.0.65
Not Applicable
Step 3 If you want to install a new version, perform these steps.
a) If you need to set a static IP address for the Management interface, see (Optional) Change Management
Network Settings at the CLI, on page 107. By default, the Management interface uses DHCP.
You will need to download the new image from a server accessible from the Management interface.
b) Perform the reimage procedure in the FXOS troubleshooting guide.
After the firewall reboots, you connect to the FXOS CLI again.
c) At the FXOS CLI, you are prompted to set the admin password again.
(Optional) Change Management Network Settings at the CLI
If you cannot use the default management IP address, then you can connect to the console port and perform
initial setup at the CLI, including setting the Management IP address, gateway, and other basic networking
settings. You can only configure the Management interface settings; you cannot configure inside or outside
interfaces, which you can later configure in the GUI.
You cannot repeat the CLI setup script unless you clear the configuration; for example, by reimaging. However,
all of these settings can be changed later at the CLI using configure network commands. See Cisco Secure
Firewall Threat Defense Command Reference.
Note
Cisco Firepower 2100 Getting Started Guide
107
Threat Defense Deployment with the Device Manager
(Optional) Change Management Network Settings at the CLI
To Next Page
Loading...
Need help?
General