Cisco Firepower 2100

Step 5 Click Save.
Configure NAT
A typical NAT rule converts internal addresses to a port on the outside interface IP address. This type of NAT
rule is called interface Port Address Translation (PAT).
Procedure
Step 1 Choose Devices > NAT, and click New Policy > Threat Defense NAT.
Step 2 Name the policy, select the device(s) that you want to use the policy, and click Save.
Figure 109: New Policy
The policy is added the management center. You still have to add rules to the policy.
Cisco Firepower 2100 Getting Started Guide
158
Threat Defense Deployment with CDO
Configure NAT