Cisco Firepower 2100

Figure 15: IPv4 Tab
• IPv6—Check the Autoconfiguration check box for stateless autoconfiguration.
Figure 16: IPv6 Tab
f) Click OK.
Step 5 Click Save.
Configure the DHCP Server
Enable the DHCP server if you want clients to use DHCP to obtain IP addresses from the threat defense.
Procedure
Step 1 Choose Devices > Device Management, and click Edit ( ) for the device.
Step 2 Choose DHCP > DHCP Server.
Cisco Firepower 2100 Getting Started Guide
32
Threat Defense Deployment with the Management Center
Configure the DHCP Server