Cisco Firepower 2100 User Manual

Install the firewall. See the hardware installation guide.Pre-Configuration
Review the Network Deployment and Default Configuration, on page 201.Pre-Configuration
Cable the Device, on page 204.Pre-Configuration
Power on the Firewall, on page 205.Pre-Configuration
Enable Platform Mode, on page 205.ASA CLI
(Optional) Change the FXOS and ASA Management IP Addresses or Gateway, on page 208:
Change the Management IP: ASA.
ASA CLI
(Optional) Change the FXOS and ASA Management IP Addresses or Gateway, on page 208:
Change the Management IP: FXOS.
FXOS CLI
(Optional) Log Into the Chassis Manager, on page 213.Chassis Manager
(Optional) Enable Additional Interfaces in the Chassis Manager, on page 214.Chassis Manager
Log Into ASDM, on page 216.ASDM
Configure Licensing, on page 217: Obtain feature licenses.Cisco Commerce
Workspace
Configure Licensing, on page 217: Generate a license token for the chassis.Smart Software Manager
Configure Licensing, on page 217: Configure feature licenses.ASDM
Configure the ASA, on page 223.ASDM
(Optional) Configure Management Access for FXOS on Data Interfaces, on page 224: Enable
FXOS remote management; allow FXOS to initiate management connections from an ASA
interface.
ASDM
(Optional) Configure Management Access for FXOS on Data Interfaces, on page 224: Configure
access lists to allow your management addresses; enable SNMP (HTTPS and SSH are enabled
by default).
Chassis Manager
Cisco Firepower 2100 Getting Started Guide
200
ASA Deployment with ASDM
End-to-End Procedure

Cisco Firepower 2100 Specifications

General

Brand	Cisco
Model	Firepower 2100
Category	Gateway
Language	English