Cisco Firepower 2100

Procedure
Step 1 Choose Devices > Device Management, and click Edit ( ) for the device.
Step 2 Choose DHCP > DHCP Server.
Figure 58: DHCP Server
Step 3 On the Server page, click Add, and configure the following options:
Figure 59: Add Server
• Interface—Choose the interface from the drop-down list.
• Address Pool—Set the range of IP addresses from lowest to highest that are used by the DHCP server.
The range of IP addresses must be on the same subnet as the selected interface and cannot include the
IP address of the interface itself.
• Enable DHCP Server—Enable the DHCP server on the selected interface.
Step 4 Click OK.
Cisco Firepower 2100 Getting Started Guide
83
Threat Defense Deployment with a Remote Management Center
Configure the DHCP Server