Cisco HWIC-4ESW - Page 113

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Configuration Examples for EtherSwitch HWICs
113
Book Title
Building configuration...
Current configuration :82 bytes
!
interface Vlan2
ip address 192.168.5.90 255.255.255.0
ip pim sparse-mode
end
Router#
Router# show ip igmp group
IGMP Connected Group Membership
Group Address Interface Uptime Expires Last Reporter
209.165.200.225 Vlan1 01:06:40 00:02:20 192.168.41.101
209.165.200.226 Vlan2 01:07:50 00:02:17 192.168.5.90
209.165.200.227 Vlan1 01:06:37 00:02:25 192.168.41.100
209.165.200.228 Vlan2 01:07:40 00:02:21 192.168.31.100
209.165.200.229 Vlan1 01:06:36 00:02:22 192.168.41.101
209.165.200.230 Vlan2 01:06:39 00:02:20 192.168.31.101
Router#
Router# show ip mroute
IP Multicast Routing Table
Flags:D - Dense, S - Sparse, B - Bidir Group, s - SSM Group, C -
Connected,
L - Local, P - Pruned, R - RP-bit set, F - Register flag,
T - SPT-bit set, J - Join SPT, M - MSDP created entry,
X - Proxy Join Timer Running, A - Candidate for MSDP Advertisement,
U - URD, I - Received Source Specific Host Report
Outgoing interface flags:H - Hardware switched
Timers:Uptime/Expires
Interface state:Interface, Next-Hop or VCD, State/Mode
(*, 209.165.200.230), 01:06:43/00:02:17, RP 0.0.0.0, flags:DC
Incoming interface:Null, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan1, Forward/Sparse, 01:06:43/00:02:17
(*, 209.165.200.226), 01:12:42/00:00:00, RP 0.0.0.0, flags:DCL
Incoming interface:Null, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan2, Forward/Sparse, 01:07:53/00:02:14
(*, 209.165.200.227), 01:07:43/00:02:22, RP 0.0.0.0, flags:DC
Incoming interface:Null, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan1, Forward/Sparse, 01:06:40/00:02:22
Vlan2, Forward/Sparse, 01:07:44/00:02:17