Cisco HWIC-4ESW - Page 114

Cisco HWIC-4ESW and HWIC-D-9ESW EtherSwitch Interface Cards
Configuration Examples for EtherSwitch HWICs
114
Book Title
(*, 209.165.200.2282), 01:06:43/00:02:18, RP 0.0.0.0, flags:DC
Incoming interface:Null, RPF nbr 0.0.0.0
Outgoing interface list:
Vlan1, Forward/Sparse, 01:06:40/00:02:18
Vlan2, Forward/Sparse, 01:06:43/00:02:16
Router#
Storm-Control: Example
The following example shows bandwidth-based multicast suppression being enabled at 70 percent on
Fast Ethernet interface 2:
Router# configure terminal
Router(config)# interface FastEthernet0/3/3
Router(config-if)# storm-control multicast threshold 70.0 30.0
Router(config-if)# end
Router# show storm-control multicast
Interface Filter State Upper Lower Current
--------- ------------ ----- ----- -------
Fa0/1/0 inactive 100.00% 100.00% N/A
Fa0/1/1 inactive 100.00% 100.00% N/A
Fa0/1/2 inactive 100.00% 100.00% N/A
Fa0/1/3 inactive 100.00% 100.00% N/A
Fa0/3/0 inactive 100.00% 100.00% N/A
Fa0/3/1 inactive 100.00% 100.00% N/A
Fa0/3/2 inactive 100.00% 100.00% N/A
Fa0/3/3 Forwarding 70.00% 30.00% 0.00%
Fa0/3/4 inactive 100.00% 100.00% N/A
Fa0/3/5 inactive 100.00% 100.00% N/A
Fa0/3/6 inactive 100.00% 100.00% N/A
Fa0/3/7 inactive 100.00% 100.00% N/A
Fa0/3/8 inactive 100.00% 100.00% N/A
Ethernet Switching: Examples
• Subnets for Voice and Data: Example, page 114
• Inter-VLAN Routing: Example, page 115
• Single Subnet Configuration: Example, page 115
• Ethernet Ports on IP Phones with Multiple Ports: Example, page 116
Subnets for Voice and Data: Example
The following example shows separate subnets being configured for voice and data on the EtherSwitch
HWIC:
interface FastEthernet0/1/1
description DOT1Q port to IP Phone
switchport native vlan 50
switchport mode trunk
switchport voice vlan 150