CHAPTER 2
Handset Setup
• Handset Hardware Installation, on page 15
• Handset Battery Charging, on page 21
• Automatic Handset Configuration, on page 22
• Manual Handset Configuration, on page 22
• Handset Firmware Upgrades, on page 23
Handset Hardware Installation
Handset Package Contents
Your handset package has the following contents:
• Handset with attached belt clip. Inside the handset is the battery, with a piece of plastic over the battery
contacts.
You need to remove the plastic over the battery contacts. For more information,
see Install the Battery in the Handset, on page 16.
Note
• Charging cradle with attached USB cable.
• Regional power adapter for the charging cradle.
• Plastic cover to replace the belt clip on the handset.
Make sure that you save this small plastic cover, in case you need it.
Note
• Printed compliance document.
Related Topics
Install the Battery in the Handset, on page 16
Handset Battery Charging, on page 21
Cisco IP DECT 6800 Series User Guide
15
To Next Page
