Cisco IP DECT 210 - Turn Do Not Disturb on and off with a Star Code; Procedure; Step 1; Use Push to Talk

Turn Do Not Disturb On and Off with a Star Code
When you don't want to be disturbed by incoming calls, you can turn on do not disturb (DND). When you
handset is in DND state, the DND icon displays on the screen.
Use the star code given to you by your administrator or service provider.
To use this feature, your administrator must enable DND.
Procedure
Step 1 While your handset is idle, enter the do not disturb star code.
Step 2 To deactivate DND, enter code to cancel do not disturb.
Related Topics
Set Do Not Disturb, on page 64
Use Push to Talk
You can use the handset as a two-way radio with the Push to Talk feature. The message is played over the
handset speaker automatically. Only 1 person at a time can use Push to Talk. If you press Mute while you
are receiving a Push to Talk message, the handset speaker mutes.
Before you begin
• You need Push to Talk enabled on your handset.
• At least one more handset in the system needs Push to Talk enabled.
Procedure
Step 1 When your handset is idle, push and continue to hold Mute .
Step 2 After the Connected screen displays, you can talk.
Step 3 When your message is complete, release Mute.
Related Topics
Turn on Push To Talk, on page 69
Cisco IP DECT 6800 Series User Guide
34
Calls
Turn Do Not Disturb On and Off with a Star Code