Cisco IP DECT 210 - Set the Alert Volume; Set the Handset Vibration Mode; Set the Tone When a Key Is Pressed

Set the Alert Volume
You can change the volume of the tone that you hear when you press Emergency .
Procedure
Step 1 Press Menu .
Step 2 Select Settings > Alert volume.
Step 3 Press right or left on the ring of the navigation cluster .
Step 4 Press Ok to save the level.
Set the Handset Vibration Mode
You can set the handset to vibrate when you have an incoming call.
Procedure
Step 1 Press Menu .
Step 2 Select Settings > Vibrator.
Step 3 Highlight your choice.
• Off (default): When an incoming call rings on the handset, the handset doesn't vibrate.
• Vibrate then ring: When an incoming call rings on the handset, the handset vibrates and then rings.
• Vibrate only: When an incoming call rings on the handset, the handset vibrates. You do not hear the
ringtone.
• Vibrate and ring: When an incoming call rings on the handset, the handset vibrates and rings at the
same time.
Step 4 Press Select to save the setting.
Set the Tone When a Key is Pressed
You can set the sound you hear when you press a key.
Procedure
Step 1 Press Menu .
Cisco IP DECT 6800 Series User Guide
57
Settings
Set the Alert Volume