Cisco IP DECT 210 - End a Call; Hold and Resume a Call; Swap between Active and Held Calls; Mute Your Call

End a Call
Procedure
Press Power/End .
Hold and Resume a Call
You can put a call on hold and then resume it.
Procedure
Step 1 From an active call, press Hold.
Step 2 Press Resume to pick the call back up.
Swap Between Active and Held Calls
When you have an active call and a held call, you can easily swap the calls. The current active calls goes on
hold and the previously held call becomes the active call.
Procedure
Press Swap.
Mute Your Call
You can mute yourself, so that others on the call can't hear you.
Procedure
Step 1 Press Mute .
Step 2 To unmute yourself, press Mute again.
Cisco IP DECT 6800 Series User Guide
30
Calls
End a Call