4
Installation Instructions
4.1
Choose Your Mounting Location
A good mounting location is important to getting the best performance out of your MR36-HW
access point. Keep the following in mind:
1.
The device should have unobstructed line of sight to most coverage areas. For example, if
installing
in an office filled with workspaces divided by mid-height cubicle walls, installing on
the ceiling or high on a wall would be ideal.
2.
Power over Ethernet supports a maximum cable length of 300 ft (100 m).
3.
If being used in a mesh deployment, the MR36-HW should have line of sight to at least two
other Meraki
devices. For more detailed instructions regarding access point location selection,
reference the Meraki
Network Design Guide (meraki.com/library/product).
4.2
Install the MR36-HW
For most mounting scenarios, the MR36-HW mount plate provides a quick, simple, and flexible means
of mounting your device. The installation should be done in two steps. First, install the mount plate to
your selected location. Then, attach the MR36-HW to the mount plate.
!!! This equipment is only suitable for mounting at heights ≤ 2 m !!!
4.2.1
Attach the Mount Plate
The MR36-HW mount plate can be used to install your access point in a wide range of scenarios: wall
or solid ceiling, below a drop ceiling, on various electrical junction boxes, or above a drop ceiling (in
the plenum).
The mount plate contains a variety of hole patterns that are customized for each installation scenario.
The
mounting template (included inbox with mount plate) should be used to drill holes for wall mounts
and also to
identify the correct hole patterns in the mount plate that should be used for each type of
mount.
The following images also show the hole patterns that should be used for each type of mount:
To Next Page
Loading...
Need help?
General
