2.3
Security Features
The MR36-HW features multiple options for physically securing the access point after installation:
1.
Security screw – The accessory kit includes screws that can be used to secure the
access point to
the mount plate. Engaging the security screw prevents accidental
dislodging and theft.
2.
Kensington lock – The access point contains a hard point that allows it to be secured to
any nearby permanent structure using a standard Kensington lock.
2.4
Ethernet Ports
The MR36-HW features an Ethernet RJ45 port that accepts 802.3af power (labeled “PoE”). This port
should
be used for uplink to your WAN connection.
2.5
Power Source Options
The MR36-HW access point can be powered using either the Meraki AC Adapter or 802.3af PoE
Injector (both sold
separately) or a third-party 802.3af PoE switch.
2.6
Factory Reset Button
If the button is pressed and held for at least five seconds and then released, the MR36-HW will
reboot and be
restored to its original factory settings by deleting all configuration information stored on
the unit.
To Next Page
Loading...
Need help?
General
