EasyManua.ls Logo

Cisco Meraki MR36-HW - Power with PoE Switch; Mount the MR36-HW

Cisco Meraki MR36-HW
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
4.2.2.1
Powering the MR36-HW with the Meraki AC Adapter (sold separately)
1.
Plug the power cord into the MR36-HW and the other end into a wall outlet.
2.
Plug an Ethernet cable that is connected to an active Ethernet connection into the Eth0 port on
the MR36-HW.
4.2.2.2
Powering the M410-HW with the Meraki 802.3at Power over Ethernet Injector (sold
separately)
1.
Plug the power cord into the PoE Injector and the other end into wall power.
2.
Plug an Ethernet cable that is connected to an active Ethernet connection into the IN port on
the injector.
3.
Route Ethernet cable from the OUT port on the injector to the Eth0 port in the cable bay of the
MR36-HW.

Related product manuals