Figure 21: Four Post Slider Preparation
Align the sliders left front-left rear or right front-right rear as shown.1
Flange facing side during assembly.2
Once the shoulder rivets are aligned, slide in the sliders as shown in the arrow mark.SLIDE
Step 3 Integrate the slider to the four post 19" rack.
Figure 22: Slider Integration to the Four Post 19" Rack
Left side four-post slide assembly1
Hardware Installation Guide for Cisco NCS 1001
24
Install Cisco NCS 1001
Install Four Post Slider into EIA/ANSI Rack
To Next Page
Loading...
