Right side four-post slide assembly2
Slider fixing screws (part number - 48-101524-01)3
Ensure that the edge surface of the 19" rack and the inner surface of the sliding rail are properly
mated while assembling the sliding rail.
Note
Figure 23: Mating for the Four Post 19" Rack
Edge surface of the rack1
Inner surface of the sliding bracket2
Step 4 Integrate the slider to the four post 23" rack.
Hardware Installation Guide for Cisco NCS 1001
25
Install Cisco NCS 1001
Install Four Post Slider into EIA/ANSI Rack
To Next Page
Loading...
