Cisco NCS 540 Series Routers

end-policy-map
To end the configuration of a policy map and to exit policy map configuration mode, use the end-policy-map
command in policy map configuration mode.
end-policy-map
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Policy map configuration
Command History
ModificationRelease
This command was introduced.Release 6.0
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
OperationsTask
ID
read,
write
qos
Examples
This example shows how to end the policy map configuration and exit policy map configuration
mode.
RP/0/RP0/CPU0:router(config)# policy-map policy1
RP/0/RP0/CPU0:router(config-pmap)# class class1
RP/0/RP0/CPU0:router(config-pmap-c)# police rate 250
RP/0/RP0/CPU0:router(config-pmap)# end-policy-map
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
7
QoS Classification Commands
end-policy-map