Congestion Avoidance Commands
All commands applicable for the Cisco NCS 5500 Series Router are also supported on the Cisco NCS 540
Series Router that is introduced from Cisco IOS XR Release 6.3.2. References to earlier releases in Command
History tables apply to only the Cisco NCS 5500 Series Router.
Note
This chapter describes commands used to avoid congestion.
Congestion avoidance is achieved through packet dropping.
• bandwidth (QoS), on page 64
• bandwidth remaining, on page 66
• queue-limit, on page 68
• random-detect, on page 71
• service-policy (interface), on page 73
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
63
To Next Page
Loading...
