Cisco NCS 540 Series Routers User Manual

end-class-map
To end the configuration of match criteria for the class and to exit class map configuration mode, use the
end-class-map command in class map configuration mode.
end-class-map
Syntax Description
This command has no keywords or arguments.
Command Default
No default behavior or values
Command Modes
Class map configuration
Command History
ModificationRelease
This command was introduced.Release 6.0
Usage Guidelines
No specific guidelines impact the use of this command.
Task ID
OperationsTask
ID
read,
write
qos
Examples
This example shows how to end the class map configuration and exit class map configuration mode:
RP/0/RP0/CPU0:router(config)# class-map class1
RP/0/RP0/CPU0:router(config-cmap)# match access-group ipv4 1
RP/0/RP0/CPU0:router(config-cmap)# end-class-map
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
6
QoS Classification Commands
end-class-map

Cisco NCS 540 Series Routers Specifications

General

Brand	Cisco
Model	NCS 540 Series Routers
Category	Network Router
Language	English