Cisco NCS 540 Series Routers

show qos interface
To display QoS information for a specific interface, use the show qos interface command in the XR EXEC
mode.
show qos interface interface-name {input|output}[location node-id]
Syntax Description
Interface name. For more information about the
syntax for the router, use the question mark (?) online
help function.
Use the show interfaces command to see
a list of all interfaces currently configured
on the router.
Note
interface-name
Attaches the specified policy map to the input
interface.
input
Attaches the specified policy map to the output
interface.
output
(Optional) Displays detailed QoS information for the
designated node. The node-id argument is entered
in the rack/slot/module notation.
location node-id
Command Default
No default behavior or values
Command Modes
XR EXEC mode
Command History
ModificationRelease
This command was introduced.Release 6.0
Usage Guidelines
The show qos interface command displays configuration for all classes in the service policy that is attached
to an interface.
Use this command to check the actual values programmed in the hardware from the action keywords in the
police rate command.
Task ID
OperationsTask
ID
readqos
Examples
This is the sample output shows the QoS information on a interface hundredGigE 0/6/0/18
that are in the input direction:
RP/0/RP0/CPU0:router# show qos interface hundredGigE 0/6/0/18 input
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
49
Congestion Management Commands
show qos interface