Cisco NCS 540 Series Routers User Manual

hw-module profile qos ingress-model peering
To enable the peering QoS profile feature, use the hw-module profile qos ingress-model peering command
in the XR Config mode. To disable this feature, use the no form of this command.
hw-module profile qos ingress-model peering [locationnode-id]
Syntax Description
Indicates the designated node. The node-id argument is entered in the rack/slot/module
notation.
location node-id
Command Default
The peering QoS profile feature is disabled by default, unless enabled by this command.
Command Modes
XR Config mode
Command History
ModificationRelease
This command was introduced.Release
6.2.1
Usage Guidelines
The router must be reloaded for the hw-module command to be functional.
Task ID
OperationTask
ID
read,
write
qos
The following example shows how to enable the peering QoS profile feature.
RP/0/RP0/CPU0:router#config
RP/0/RP0/CPU0:router(config)#hw-module profile qos ingress-model peering
RP/0/RP0/CPU0:router(config)#commit
RP/0/RP0/CPU0:router# reload
Modular QoS Command Reference for Cisco NCS 5500 Series and Cisco NCS 540 Series Routers
8
QoS Classification Commands
hw-module profile qos ingress-model peering

Cisco NCS 540 Series Routers Specifications

General

Brand	Cisco
Model	NCS 540 Series Routers
Category	Network Router
Language	English