Cisco Nexus 6000 Series - Configuring Interface LLDP

PurposeCommand or Action
Use the port-description option to specify the port description
TLV messages.
Use the port-vlan option to specify the port VLAN ID TLV
messages.
Use the system-capabilities option to specify the system
capabilities TLV messages.
Use the system-description option to specify the system
description TLV messages.
Use the system-name option to specify the system name TLV
messages.
Resets the LLDP values to their defaults.switch(config)# no lldp
{holdtime | reinit | timer}
Step 3
Displays LLDP configurations.(Optional)switch# show lldp
Step 4
This example shows how to configure the global LLDP hold time to 200 seconds:
switch# configure terminal
switch(config)# lldp holdtime 200
switch(config)#
This example shows how to enable LLDP to send or receive the management address TLVs:
switch# configure terminal
switch(config)# lldp tlv-select management-address
switch(config)#
Configuring Interface LLDP
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Selects the interface to change.
switch(config)# interface type slot/port
Step 2
If this is a 10G breakout port, the slot/port
syntax is QSFP-module/port.
Note
Sets the selected interface to either receive or
transmit.
switch(config-if)# [no] lldp {receive |
transmit}
Step 3
The no form of the command disables the LLDP
transmit or receive.
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
108
Configuring LLDP
Configuring Interface LLDP