Cisco Nexus 6000 Series - Verifying VTP Configuration

PurposeCommand or Action
(Optional)
Displays information about VTP advertisement
statistics on the device.
switch# show vtp counters
Step 12
(Optional)
Displays the list of VTP-enabled interfaces.
switch# show vtp interface
Step 13
(Optional)
Displays the password for the management VTP
domain.
switch# show vtp password
Step 14
(Optional)
This is a VTP version 3 command that displays
information about neighbor switches. The information
switch# show vtp devices [conflict]
Example:
Device# show vtp devices
Step 15
is not learned from the summary packet used for
regular VTP packets. This command sends out a
Gathering information from the
separate packet to collect information regarding
neighbor switches running VTP version 3.
domain, please wait.
VTP Database Conf switch ID
Primary Server Revision System
Name
lict
------------ ---- --------------
-------------- ----------
----------------------
VLAN Yes 00b0.8e50.d000
000c.0412.6300 12354
main.cisco.com
MST No 00b0.8e50.d000
0004.AB45.6000 24
main.cisco.com
VLAN Yes
000c.0412.6300=000c.0412.6300 67
qwerty.cisco.com
(Optional)
Copies the running configuration to the startup
configuration.
switch# copy running-config
startup-config
Step 16
This example shows how to configure VTP in transparent mode for the device:
switch# configure terminal
switch(config)# feature vtp
switch(config)# vtp domain accounting
switch(config)# vtp version 2
switch(config)# vtp mode transparent
switch(config)# exit
switch#
Configuring VTP V3 Pruning
Follow the steps given below to configure VTP V3 Pruning.
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
138
Configuring VTP V3
Configuring VTP V3 Pruning