CHAPTER 17
Configuring VN-Segment
This chapter contains the following sections:
•
Information About VN-Segment, page 203
•
Guidelines and Limitations for VN-Segment, page 205
•
Enabling VN-Segment, page 205
•
Configuring VN-Segment for a VLAN, page 206
•
Configuring VN-Segment for VLAN in Configure Sync, page 207
•
Configuring VN-Segment in Transit Mode, page 207
•
Configuring VN-Segment in Non-Transit Mode, page 208
•
Disabling VN-Segment, page 208
•
Verifying VN-Segment Configuration, page 209
Information About VN-Segment
The VN-Segment feature defines a new way to "tag" packets on the wire replacing the traditional 802.1Q
VLAN tag. This feature uses a 24-bit tag also referred to as a Virtual Network Identifier (VNI). CE links
(access and trunk) carry traditional VLAN tagged/untagged frames. These are the VN-Segment Edge ports.
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
203
To Next Page
Loading...
