Cisco Nexus 6000 Series - Verifying Private VLAN Configuration

Verifying the Private VLAN Configuration
Use the following commands to display PVLAN configuration information.
PurposeCommand
Displays the features enabled on the switch.switch# show feature
Displays information on all interfaces configured as
switch ports.
switch# show interface switchport
Displays the status of the PVLAN.switch# show vlan private-vlan [type]
This example shows how to display the PVLAN configuration:
switch# show vlan private-vlan
Primary Secondary Type Ports
------- --------- --------------- -------------------------------------------
5 100 community
5 101 community Eth1/12, Eth100/1/1
5 102 community
5 110 community
5 200 isolated Eth1/2
switch# show vlan private-vlan type
Vlan Type
---- -----------------
5 primary
100 community
101 community
102 community
110 community
200 isolated
This example shows how to display enabled features (some of the output has been removed for brevity):
switch# show feature
Feature Name Instance State
-------------------- -------- --------
fcsp 1 enabled
...
interface-vlan 1 enabled
private-vlan 1 enabled
udld 1 disabled
...
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
42
Configuring Private VLANs
Verifying the Private VLAN Configuration