Cisco Nexus 6000 Series - Configuring VN-Segment for VLAN in Configure Sync; Configuring VN-Segment in Transit Mode

Configuring VN-Segment for VLAN in Configure Sync
VN-Segments can be configured with the configure sync command for VPCs.
Procedure
PurposeCommand or Action
Enter configuration sync mode.switch# configure sync
Step 1
Creates a switch profile that contains a
predetermined configuration.
switch(config-sync)# switch-profile test
Step 2
Creates a VLAN.
switch(config-sync-sp)# vlan vlan-id
Step 3
Defines the network global ID.switch(config-sync-sp-vlan)#
vn-segment segmentation-id
Step 4
The segmentation-id range is from 4096 to
16,773,119.
(Optional)
Synchronizes the configuration with the peer switch
and applies the configuration locally.
switch(config-sync-sp-vlan)# commit
Step 5
Saves the change persistently through reboots and
restarts by copying the running configuration to the
startup configuration.
switch(config-sync-sp-vlan)# copy
running-config startup-config
Step 6
This example shows how to configure VN-Segment for a VLAN in configure sync mode:
switch# configure sync
switch(config-sync)# switch-profile test
Switch-Profile started, Profile ID is 1
switch(config-sync-sp)# vlan 3500
switch(config-sync-sp-vlan)# vn-segment 40001
switch(config-sync-sp-vlan)#
Configuring VN-Segment in Transit Mode
Before You Begin
The FabricPath feature set must be enabled.
Procedure
PurposeCommand or Action
Enters global configuration mode.switch# configure terminal
Step 1
Enables transit mode. You need to save the configuration
and reload the spine.
switch(config)# fabricpath mode
transit
Step 2
Cisco Nexus 6000 Series NX-OS Layer 2 Switching Configuration Guide, Release 7.x
207
Configuring VN-Segment
Configuring VN-Segment for VLAN in Configure Sync