Cisco Nexus 7000 - Document Conventions

Send document comments to nexus7k-docfeedback@cisco.com
Cisco Nexus 7000 Series NX-OS High Availability Commands
clear xbar-driver
HACR-4
Cisco Nexus 7000 Series NX-OS High Availability Command Reference, Release 5.x
OL-23374-01
clear xbar-driver
To delete the crossbar-related information, use the clear x-bar driver command.
clear xbar-driver [xbar xbar-number | local xbar slot-number]
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to delete the crossbar-related information:
switch(config)# clear xbar-driver xbar 2 inst 1 counters port_num 1 all
switch(config)#
Related Commands
xbar
xbar-number
(Optional) Specifies the crossbar number. The range is from 1 to 5.
local xbar slot-
number
(Optional) Specifies the crossbar slot number. The range is from 1 to 4.
Release Modification
4.0(1) This command was introduced.
Command Description
show module fabric Displays information about the module fabric.
show hardware
fabric-utilization
Displays information about the hardware fabric utilization.