Cisco Nexus 7000 - Cisco Nexus 7010 System

Send document comments to nexus7k-docfeedback@cisco.com
Cisco Nexus 7000 Series NX-OS High Availability Commands
system test-preupgrade running-ver
HACR-23
Cisco Nexus 7000 Series NX-OS High Availability Command Reference, Release 5.x
OL-23374-01
system test-preupgrade running-ver
To test the running software version before an upgrade, use the system test-preupgrade running-ver
command.
system test-preupgrade running-ver running-version target-ver target-version swid software-id
impact impact-number
Syntax Description
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to test the running software version before an upgrade:
switch(config)# system test-preupgrade running-ver 4.2<0.202> target-ver Update
swid 4.2.1 impact 0
System will be upgraded according to following table:
Module Swid Impact Running-Version New-Version Upg-Required
------ ---------- ---------- -------------------- -------------------- ------------
6 4.2.1 hitless 4.2<0.202> Update
1
9 4.2.1 hitless 4.2<0.202> Update
1
running-version Running software version.
target-ver Specifies the target software version.
target-version Target software version.
swid Specifies the software ID of the image running on a module. For example: system
or kickstart.
software-id Software ID.
impact Specifies the impact. For example: 0 for hitless and 1 for hitful.
impact-number Impact number.
Release Modification
4.0(1) This command was introduced.