Send document comments to nexus7k-docfeedback@cisco.com
Cisco Nexus 7000 Series NX-OS High Availability Commands
system standby manual-boot
HACR-21
Cisco Nexus 7000 Series NX-OS High Availability Command Reference, Release 5.x
OL-23374-01
system standby manual-boot
To enable the system standby manual boot, use the system standby manual-boot command.
system standby manual-boot
Syntax Description This command has no arguments or keywords.
Defaults None
Command Modes Any command mode
Supported User Roles network-admin
network-operator
vdc-admin
vdc-operator
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to enable the system standby manual boot:
switch(config)# system standby manual-boot
system standby manual-boot option is enabled
switch(config)#
Related Commands
Release Modification
4.0(1) This command was introduced.
Command Description
system hap-reset Enables the Supervisor Reset HA policy.
To Next Page
Loading...
