Cisco Nexus 7000 - Page 16

Send document comments to nexus7k-docfeedback@cisco.com
Cisco Nexus 7000 Series NX-OS High Availability Commands
poweroff
HACR-6
Cisco Nexus 7000 Series NX-OS High Availability Command Reference, Release 5.x
OL-23374-01
poweroff
To power off a supervisor of a line card module in the Cisco NX-OS, use the poweroff command.
poweroff {module module-number | xbar xbar-number}
Syntax Description
Defaults None
Command Modes Global configuration mode
Supported User Roles network-admin
vdc-admin
Command History
Usage Guidelines This command does not require a license.
Examples This example shows how to take a supervisor module out of service:
switch# configure terminal
switch(config)# poweroff module 5
Related Commands
module module-number Specifies an I/O module. The range is from 1 to 18.
xbar xbar-number Specifies a fabric module. The range is from 1 to 5.
Release Modification
4.0(1) This command was introduced.
Command Description
out-of-service Shuts down a supervisor module in the Cisco NX-OS software.
reload module Reloads a module in a device.