Figure 26: Unlocking a Fabric Module from its Slot
Pull the handles to partially remove the module from
the slot.
3Press both eject buttons.1
Handles spring out from the module.2
b) Grasp each of the two levers with your two hands and fully rotate the levers out 90 degrees from the fabric module.
c) Pull both levers until the fabric module is about 3 inches (7 cm) out of the chassis (see Callout 3 in the previous
figure).
d) Rotate both levers back to the front of the module (see Callout 1 in the following figure).
Each lever clicks when it locks in place at the front of the module.
Cisco Nexus 7710 Switch Site Preparation and Hardware Installation Guide
OL-30452-01.124
Installing or Replacing Modules, Fan Trays, and Power Supplies
Installing or Replacing a Fabric Module
To Next Page
Loading...
