Figure 7: Moving a Chassis onto a Rack or Cabinet
Rack vertical mounting rails.3Push the sides of the lower half of the front side of
the chassis.
1
Chassis mounting brackets.2
To adjust the placement of the chassis on the bottom-support rails, you can use the handles on the sides of
the chassis.
Tip
Step 5 If the mechanical lift is raised above the height of the bottom-support rails, gently lower it to the level of the rails or
no more than 1/4 inch (0.6 cm) below the rails.
This action helps to prevent the bottom of the chassis from getting caught on the expansion edges of the rail.
Step 6 Push the chassis all the way onto the rack so that the vertical mounting brackets on the chassis come in contact with
the vertical mounting rails on the rack.
Step 7 Use six M6 x 19 mm or 24 x 3/4-inch screws to attach each of the two vertical mounting brackets on the chassis to the
two vertical mounting rails on the rack (total of 12 screws). See Callout 2 in the following figure.
Cisco Nexus 7710 Switch Site Preparation and Hardware Installation Guide
25OL-30452-01.
Installing the Chassis
Installing a Chassis on a Rack or Cabinet
To Next Page
Loading...
