b) Fasten the air filter to the cable-management assembly with the two M4 x 12 mm screws on top and four M3 x 12
mm screws below. Tighten the M4 screws to 11.5 to 15 in-lbs (1.3 to 1.7 N·m) of torque, and tighten the M3 screws
to 5 to 7 in-lb (0.56 to 0.79 N.m) of torque.
c) Repeat Steps 3a and 3b to attach the other air filter to the cable management assembly on the other side of the chassis.
Cisco Nexus 7710 Switch Site Preparation and Hardware Installation Guide
OL-30452-01.40
Installing the Chassis
Installing Air Filters
To Next Page
Loading...
