Note: Receiver sensitivity is the minimum signal needed to decode a packet at a certain data rate.
The above values are pure radio specifications and do not account for the gain of the single integrated antenna.
To achieve 802.11n/ac connectivity, it is recommended that the Cisco IP Phone 8861 and 8865 be within 100 feet of the access
point.
Regulatory
World Mode (802.11d) allows a client to be used in different regions, where the client can adapt to using the channels and
transmit powers advertised by the access point in the local environment.
The Cisco IP Phone 8861 and 8865 operate best when the access point is 802.11d enabled, where it can determine which
channels and transmit powers to use per the local region.
Enable World Mode (802.11d) for the corresponding country where the access point is located.
Some 5 GHz channels are also used by radar technology, which requires that the 802.11 client and access point be 802.11h
compliant if utilizing those radar frequencies (DFS channels). 802.11h requires 802.11d to be enabled.
The Cisco IP Phone 8861 and 8865 will passively scan DFS channels first before engaging in active scans of those channels.
If 802.11d is not enabled, then the Cisco IP Phone 8861 and 8865 can attempt to connect to the access point using reduced
transmit power.
Below are the countries and their 802.11d codes that are supported by the Cisco IP Phone 8861 and 8865.
To Next Page
Loading...
Need help?
General