EasyManuals Logo

Cisco PenTeleData 8800 Series Deployment Guide

Cisco PenTeleData 8800 Series
207 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #203 background imageLoading...
Page #203 background image
Cisco IP Phone 8861 and 8865 Wireless LAN Deployment Guide
203
Status Messages
Status messages can be viewed locally on the phone under Applications > Admin settings > Status > Status messages.
Restoring Factory Defaults
The configuration of the Cisco IP Phone 8861 and 8865 can be reset to factory defaults by selecting Applications > Admin
settings > Reset settings > All settings.
A confirmation screen will appear where Reset must be selected to proceed with the factory data reset.
If the Cisco IP Phone 8861 or 8865 is not able to boot properly, a factory reset can also be initiated via the following procedure:
Turn the phone off by disconnecting the power.
Press and hold the # key, then power on the phone.
Keep the # key held until the Mute LED turns off.
Once the Mute LED turns off, release the # key.
Then press 1 2 3 4 5 6 7 8 9 * 0 #.
The Mute LED will turn on to indicate the factory reset sequence has been accepted.
The Cisco IP Phone 8861 or 8865 will then continue the normal boot process and have the factory settings restored.
To boot the alternate image, perform the following procedure.

Table of Contents

Other manuals for Cisco PenTeleData 8800 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco PenTeleData 8800 Series and is the answer not in the manual?

Cisco PenTeleData 8800 Series Specifications

General IconGeneral
BrandCisco
ModelPenTeleData 8800 Series
CategoryIP Phone
LanguageEnglish

Related product manuals