Note: Cisco Meraki access points support 802.11r (FT) for fast secure roaming, but do not support Cisco Centralized Key
Management (CCKM).
If WPA2-Enterprise is enabled where the Cisco Meraki authentication server will be utilized as the RADIUS server, then a
user account must be created on the Network-wide > Configure > Users page, which the Cisco IP Phone 8861 and 8865 will
be configured to use for 802.1x authentication.
Note: Cisco Meraki access points do not support EAP-FAST.
On the Wireless > Configure > Access control page, recommend to enable Bridge mode, where the Cisco IP Phone 8861 and
8865 will obtain DHCP from the local LAN instead of the Cisco Meraki network; unless call control, other endpoints, etc. are
cloud-based.
To Next Page
Loading...
Need help?
General