Cisco RJ-45-to-AUX - Configuring a VTP Domain on a Catalyst 1900 Switch; Setting a VTP Domain Password on a Catalyst Switch; Configuring a Catalyst 1900 Switch as a VTP Server; Configuring a Catalyst 1900 Switch as a VTP Client

5000> (enable) set vtp v2 enable
This command will enable the version 2 function in the entire
management domain.
All devices in the management domain should be version2−capable
before enabling.
Do you want to continue (y/n) [n]? y
VTP domain modified
5000> (enable)
Configuring a VTP Domain on a Catalyst 1900 Switch
The 1900EN series switches only use VTP version 1. The switch can be a member of only one VTP domain.
To set the switch to the Coriolis domain, use the following command:
1912(config)# vtp domain coriolis
Setting a VTP Domain Password on a Catalyst Switch
To set the VTP domain password to 1234 on a Catalyst 1900, use the following command:
1912(config)# vtp password 1234
Configuring a Catalyst 1900 Switch as a VTP Server
The 1900EN series switches only use VTP version 1. No configuration options exist for VTP versions. To set
the switch as a VTP server for the domain use the following command:
1912(config)# vtp server
Configuring a Catalyst 1900 Switch as a VTP Client
To configure the switch as a VTP client use the following command:
1912(config)# vtp client
Configuring a Catalyst 1900 Switch for Transparent Mode
To configure the switch to operate in transparent mode, use the following command:
1912(config)# vtp transparent
109