Cisco RJ-45-to-AUX - Configuring RGMP on the Switch; Disabling RGMP on the Switch; Configuring RGMP on the Router; Disabling RGMP on the Router

valid igmp leaves received 0
valid igmp queries received 568
igmp gs queries transmitted 0
igmp leaves transmitted 0
failures to add GDA to EARL 0
topology notifications received 10
number of CGMP packets dropped 2456875
Configuring RGMP on the Switch
RGMP is disabled by default. Use the following command to enable RGMP globally:
Coriolis> (enable) set rgmp enable
RGMP enabled.
Disabling RGMP on the Switch
To disable RGMP, use the following command:
Coriolis> (enable) set rgmp disable
RGMP disabled.
Configuring RGMP on the Router
RGMP must be enabled on each interface that has the appropriate topology. Use this command:
Router(config)# vlan−interface 3
Router(config−if)# ip rgmp
Disabling RGMP on the Router
To disable RGMP, use the following command:
Router(config)# vlan−interface 3
Router(config−if)# no ip rgmp
Note Here are some related commands that you can try on the router:
debug ip rgmp [group_name | group_address]
show ip rgmp interface [interface_unit_name]
show ip rgmp groups [group_name | group_address]
Displaying RGMP Groups
To display all the multicast groups that were joined by RGMP−capable routers, use the following command:
Coriolis> (enable) show rgmp group
VlanDest MAC/Route DesRGMP Joined Router Ports
————————————————————————————————————————————————
201−00−5e−46−85−111/1,2/14
101−00−5e−14−11−285/1
Total Number of Entries = 2
‘*’ − Configured
155