Viewing the VTP Domain Configuration on a Set/Clear IOS
The show vtp domain command can be used to obtain the VTP domain configuration on a Set/Clear
command−based IOS switch. Let’s take a look at the command and an example of the output associated with
it:
Catalyst5002> (enable) show vtp domain
Domain Name Domain Index VTP Version Local Mode Password
————————————————————————— ———————————— —————————— —————————— ————————
Coriolis 1 1 Server −
Vlan−count Max−vlan−storage Config Revision Notifications
—————————— ———————————————— —————————————— ————————————
5 1023 0 enabled
Last Updater V2 Mode Pruning PruneEligible on Vlans
—————————————— ———————— ———————— ————————————————————————
68.127.187.12 disabled disabled 2−1000
Viewing the VTP Domain Configuration on a CLI−Based IOS
The show vtp command displays the VTP domain configuration on an IOS−based switch. Let’s look at the
command, its available options, and an example of its output:
1912EN#show vtp ?
statistics Show VTP statistics
<cr>
1912EN#show vtp
VTP version: 1
Configuration revision: 0
Maximum VLANs supported locally: 1005
Number of existing VLANs: 5
VTP domain name : coriolis
VTP password :
VTP operating mode : Server
VTP pruning mode : Disabled
VTP traps generation : Enabled
Configuration last modified by: 63.78.39.33 at 00−00−0000 00:00:00
1912EN#
Viewing the VLAN Configuration on a Set/Clear
Command−Based Switch
To view the VLAN configuration on a Set/Clear command−based IOS switch, use the show vlan command.
Several options are available for use with the command that allow you to see only trunked ports, only
non−trunked ports, or an individual VLAN number. Let’s look at the command, its optional syntaxes, and an
example of its output:
show vlan [vlan] [trunk|no trunk]
Catalyst5002> show vlan
Virtual LAN ID: 1
vLAN Trunk Interface: FastEthernet1/0.1
324
To Next Page
Loading...
