Configuring Long Aging on the Catalyst 6000
To configure the long aging time on the Catalyst 6000, use the following command:
mls aging long <seconds>
An example of using the mls aging long command is as follows:
mls aging long 64
Disabling Long Aging on the Catalyst 6000
To disable the long aging time on the Catalyst 6000, use the following command:
no mls aging long
Configuring Normal Aging on the Catalyst 6000
To configure the normal aging time on the Catalyst 6000, use the following command:
mls aging normal <seconds>
An example is as follows:
mls aging normal 32
Disabling Normal Aging on the Catalyst 6000
To disable the normal aging time on the Catalyst 6000, use the following command:
no mls aging normal
Assigning MLS Management to an Interface on the Catalyst 5000
To enable an interface to be a management interface, follow these steps:
Enter Interface Configuration mode on the interface using the following command:
CAT5000(config)interface fastethernet 1/1
1.
To enable the interface as the management interface, use the following command:2.
CAT5000(config)mls rp management−interface
Disabling MLS Management on an Interface on the Catalyst 5000
To disable a management interface, perform the following tasks:
Enter Interface Configuration mode on the interface using the following command:
CAT5000(config)interface fastethernet 1/1
1.
To disable the interface as the management interface, use the following command:2.
CAT5000(config−if)no mls rp management−interface
239
To Next Page
Loading...
