Configuring the IP Interface
The command cnfifip is used to set the IP address, netmask, and broadcast address. Each parameter must be
entered one at a time. The parameters are as follows:
−if—The interface (26 for Ethernet, 28 for SLIP, or 37 for ATM)•
−ip—The IP address•
−msk—The network mask•
−bc—The broadcast address•
This command has a privilege level of 1.
Displaying the Alarm Level of the Switch
The command dspshelfalm is used to display the alarm level and current status of the temperature, power
supply, fans, and voltage. This is a level 6 command.
This command provides the following information for each alarm type: the threshold, severity, measurable
(temperature−related or not), current value, and status.
67
To Next Page
Loading...
